Yealink T21PE2 - Page 320

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
314
Web UI Features->Forward&DND->Forward->AccountX->Always Forward->On/Off
Phone UI Menu->Features->Call Forward->AccountX->Always Forward->Always Forward
Parameter
account.X.always_fwd.target
[1]
<MAC>.cfg
Description
It configures the destination number of the always forward.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled) and “features.fwd_mode” is set to 1 (Cus-
tom). It is not applicable to T19(P) E2/CP920 IP phones.
Permitted
Values
String within 32 characters
Default Blank
Web UI Features->Forward&DND->Forward->AccountX->Always Forward->Target
Phone UI Menu->Features->Call Forward->AccountX->Always Forward->Forward to
Parameter
account.X.always_fwd.on_code
[1]
<MAC>.cfg
Description
It configures the always forward on code to activate the server-side always forward feature.
The IP phone will send the always forward on code and the pre-configured destination number (con-
figured by the parameter “account.X.always_fwd.target”) to the server when you activate always forward
feature on the IP phone.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled) and “features.fwd_mode” is set to 1 (Cus-
tom). It is not applicable to T19(P) E2/CP920 IP phones.
Permitted
Values
String within 32 characters
Default Blank
Web UI Features->Forward&DND->Forward->AccountX->Always Forward->On Code
Phone UI Menu->Features->Call Forward->AccountX->Always Forward->On Code
Parameter
account.X.always_fwd.off_code
[1]
<MAC>.cfg
Description
It configures the always forward off code to deactivate the server-side always forward feature.
The IP phone will send the always forward off code to the server when you deactivate always forward fea-
ture on the IP phone.
Note: It works only if “features.fwd.allow” is set to 1 (Enabled) and “features.fwd_mode” is set to 1 (Cus-
tom). It is not applicable to T19(P) E2/CP920 IP phones.
Permitted
Values
String within 32 characters
Default Blank
Web UI Features->Forward&DND->Forward->AccountX->Always Forward->Off Code
Phone UI Menu->Features->Call Forward->AccountX->Always Forward->Off Code
Parameter
account.X.busy_fwd.enable
[1]
<MAC>.cfg
Description
It triggers busy forward feature to on or off.
Note: It is not applicable to T19(P) E2 IP phones.
Permitted
0-Off