Yealink T21PE2 - Example: Configuring EDK List for a Line Key

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
184
Description
It enables or disables the custom soft key X to be displayed in the hold state.
Note: It works only if “features.enhanced_dss_keys.enable” and “softkey.X.enable” are set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default 0
Parameter
softkey.X.use.held
[1]
<y0000000000xx>.cfg
Description
It enables or disables the custom soft key X to be displayed in the held state.
Note: It works only if “features.enhanced_dss_keys.enable” and “softkey.X.enable” are set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default 0
Parameter
softkey.X.use.conferenced
[1]
<y0000000000xx>.cfg
Description
It enables or disables the custom soft key X to be displayed in the conference state.
Note: It works only if “features.enhanced_dss_keys.enable” and “softkey.X.enable” are set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default 0
Parameter
softkey.X.use.dialtone
[1]
<y0000000000xx>.cfg
Description
It enables or disables the custom soft key X to be displayed in the dial tone (no numbers entered) state.
Note: It works only if “features.enhanced_dss_keys.enable” and “softkey.X.enable” are set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default 0
Parameter
softkey.X.use.dialing
[1]
<y0000000000xx>.cfg
Description
It enables or disables the custom soft key X to be displayed in the dialing state.
Note: It works only if “features.enhanced_dss_keys.enable” and “softkey.X.enable” are set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default 0
[1]
X is the soft key ID. X=1-10.
Example: Configuring EDK List for a Line Key
The following takes an example to help you understand how to execute the macro action string.
Example
features.enhanced_dss_keys.enable = 1
edk.edklist.1.enable = 1
edk.edklist.1.mname = IVR1
edk.edklist.1.action = 1013$Tinvite$$Cwc$$Cp10$$Penter number&C4&N$$Tdtmf$$Cp3$$Chu$