Phone Network
39
You can check the Wi-Fi dongle MAC address at the path: Menu->Status->Wi-Fi MAC (phone user interface) or
Status->Status->Network Common->Wi-Fi MAC (web user interface).
Note
To use Wi-Fi feature on T48G/T48S/T46G/T46S/T42S/T41S/T29G/T27G IP phones, make sure the Wi-Fi USB dongle is prop-
erly connected to the USB port on the back of the phone. The Wi-Fi USB dongle should be purchased separately.
Topic
Wi-Fi Configuration
Wi-Fi Configuration
The following table lists the parameters you can use to configure Wi-Fi.
Parameter
static.wifi.function.enable
[1]
<y0000000000xx>.cfg
Description
It enables or disables the Wi-Fi feature.
Note: It is only applicable to T54S/T52S/T48S/T48G/T46S/T46G/T42S/T41S/T29G/T27G/CP920 IP phones.
Permitted
Values
0-Disabled
1-Enabled
Default 1
Parameter
static.network.redundancy.mode
[1]
<y0000000000xx>.cfg
Description
It configures the network connection mode to be used preferentially.
Note: It is only applicable to T54S/T52S/T48S/T48G/T46S/T46G/T42S/T41S/T29G/T27G/CP920 IP phones.
Permitted
Values
0-If Wi-Fi mode is activated, the wired network is unavailable; Wi-Fi mode must be deactivated if you
want to use the wired network.
1-Use wireless network preferentially.
2-Use wired network preferentially.
Default 0
Parameter
static.network.redundancy.failback.timeout
[1]
<y0000000000xx>.cfg
Description
It configures the time to wait (minutes) for the IP phone to switch to the preferred network (configured
by “static.network.redundancy.mode”).
Note: It works only if “static.network.redundancy.mode” is set to 1 or 2. It is only applicable to
T54S/T52S/T48S/T48G/T46S/T46G/T42S/T41S/T29G/T27G/CP920 IP phones.
Permitted
Values
Integer from 0 to 1440
0-The phone will not switch as long as the current network is available.
1 to 1440–The phone will keep using the current network for the specified time after the preferentially
used network becomes available. If the preferentially used network is still available after the specified
time, the phone performs a network switch while the phone is not in use.
Default 55
Parameter static.wifi.enable <y0000000000xx>.cfg
Description
It activates or deactivates the Wi-Fi mode.
Note: It is only applicable to T54S/T52S/T48S/T48G/T46S/T46G/T42S/T41S/T29G/T27G/CP920 IP phones. It
To Next Page
Loading...
