Yealink T21PE2 - Anonymous Call Rejection Configuration

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
292
Anonymous call rejection on a specific server, you may need to configure anonymous call rejection on code and off
code to activate and deactivate server-side anonymous call rejection feature.
Topic
Anonymous Call Rejection Configuration
Anonymous Call Rejection Configuration
The following table lists the parameters you can use to configure anonymous call rejection.
Parameter
account.X.reject_anonymous_call
[1]
<MAC>.cfg
Description It triggers the anonymous call rejection feature to on or off.
Permitted
Values
0-Off
1-On, the IP phone will automatically reject incoming calls from users enabled anonymous call feature.
The anonymous user’s phone screen presents “Anonymity Disallowed”.
Default 0
Web UI
Account->Basic->Anonymous Rejection (“account.X.anonymous_call.server_base_only” must not be left
blank)
Phone UI
T54S/T52S/T48S/T48G/T46S/T46G/T29G:
Menu->Features->Anonymous->Line X->Anonymous Rejection (“account.X.anonymous_call.server_
base_only” cannot be left blank)
T42G/T42S/T41P/T41S/T40P/T40G/T27G/T23P/T23G/T21(P) E2/T19(P) E2/CP920:
Menu->Features->Anonymous Call->Anonymous Rejection (“account.X.anonymous_call.server_base_
only” cannot be left blank)
Parameter features.anonymous_response_code <y0000000000xx>.cfg
Description
It configures the code the phone responds with to the server when it receives an anonymous call.
Note: It works only if “account.X.reject_anonymous_call“ is set to 1 (On).
Permitted
Values
Integer from 0 to 65535
Default 433
Parameter
account.X.anonymous_reject_oncode
[1]
<MAC>.cfg
Description
It configures the anonymous call rejection on code.
The IP phone will send the code to activate anonymous call rejection feature on server-side when you
activate it on the IP phone.
Example:
account.1.anonymous_reject_oncode = *74
Permitted
Values
String within 32 characters
Default Blank
Web UI None ( “account.X.anonymous_call.server_base_only” cannot be left blank)
Phone UI None ( “account.X.anonymous_call.server_base_only” cannot be left blank)