Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
220
Values 1-Enabled
Default 0
Multiple Line Keys per Account
You can assign multiple line keys to associate with a specific account. The line keys are automatically assigned with
Line type from the first unused one (unused one means the line key is configured as N/A or the associated account is
not registered). All calls on this account will be distributed evenly among these line keys. It is useful for managing a
high volume of calls to an account.
When you assign multiple line keys to be associated with an account, you can configure the IP phone whether trans-
ferring a call or setting up a conference call on the current line key or on a new distribution line key.
It is not applicable to T19(P) E2/CP920 IP phones.
Topics
Multiple Line Keys per Account Configuration
Auto Line Labels Rule Configuration
Default Account
Multiple Line Keys per Account Configuration
The following table lists the parameters you can use to configure multiple line keys per account.
Parameter features.auto_linekeys.enable <y0000000000xx>.cfg
Description
It enables or disables to assign multiple line keys to associate with a specific account.
Note: The number of the line keys is determined by “account.X.number_of_linekey”. It is not applicable to
T19(P) E2/CP920 IP phones.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Web UI Features->General Information->Auto Linekeys
Parameter
account.X.number_of_linekey
[1]
<MAC>.cfg
Description
It configures the number of line keys to be assigned with a specific account from the first unused one. If a
line key is in used, the IP phone will skip to the next unused DSS key.
Note: It is not applicable to T19(P) E2/CP920 IP phones.
Permitted
Values
Integer from 1 to 999
The number of the line keys varies by phone models, for the supported line keys, refer to Supported DSS
Keys.
Default 1
Web UI Account->Advanced->Number of line key
Parameter
phone_setting.call_appearance.transfer_via_new_
linekey
<y0000000000xx>.cfg
Description
It enables or disables to distribute a transferring call to a new line key (the new line key is not seized). If all
line keys are seized, the current line key will be used.
To Next Page
Loading...
