Yealink T21PE2 - BLF Key LedIcon and Behavior for Parked-Against State Configuration

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
428
Note: It works only if “blf.enhanced.talking.enable” is set to 1 (Enabled). It is not applicable to T19(P)
E2/CP920 IP phones.
Permitted
Values
String
Default Blank
Parameter blf.enhanced.talking.idle.action <y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is idle and monitored
user is talking.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.talking.idle.action = newcall
Note: It works only if “blf.enhanced.talking.enable” is set to 1 (Enabled). It is not applicable to T19(P)
E2/CP920 IP phones.
Permitted
Values
String
Default Blank
BLF Key LED/Icon and Behavior for Parked-Against State Configuration
The following table lists the parameters you can use to configure BLF key LED/icon and Behavior for the parked-
against state (a call is being parked against the monitored phone).
Parameter blf.enhanced.parked.enable <y0000000000xx>.cfg
Description
It enables or disables the custom configuration when a call is parked against the monitored phone.
Note: It is not applicable to T19(P) E2/CP920 IP phones.
Permitted
Values
0-Disabled
1-Enabled, the IP phone will display the custom BLF/BLF List DSS key LED status/icon colors and perform
the custom behavior when pressing the BLF/BLF List DSS key.
Default 0
Parameter blf.enhanced.parked.led <y0000000000xx>.cfg
Description
It configures the custom BLF/BLF List DSS key LED status/icon colors when a call is parked against the
monitored phone.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.parked.led = $LEDg1000o$
For T54S/T52S/T46G/T46S/T42G/T42S/T41P/T41S/T40P/T40G/T29G/T27G/T23P/T23G/T21(P) E2 IP phones,
the BLF/BLF list DSS key LED glows green for 1000ms and then goes out.
For T48G/T48S IP phones, the BLF/BLF List DSS key field displays a green icon for 1000ms and then turns
to white.
Note: It works only if “blf.enhanced.parked.enable” is set to 1 (Enabled). It is not applicable to T19(P)
E2/CP920 IP phones.