Yealink T21PE2 - Page 435

Advanced Features
429
Permitted
Values
String
Default Blank
Parameter blf.enhanced.parked.callin.action <y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is ringing and a call is
parked against the monitored phone.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.parked.callin.action = newcall
Note: It works only if “blf.enhanced.parked.enable” is set to 1 (Enabled). It is not applicable to T19(P)
E2/CP920 IP phones.
Permitted
Values
String
Default Blank
Parameter blf.enhanced.parked.talking.action <y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is talking and a call is
parked against the monitored phone.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.parked.talking.action = newcall
Note: It works only if “blf.enhanced.parked.enable” is set to 1 (Enabled). It is not applicable to T19(P)
E2/CP920 IP phones.
Permitted
Values
String
Default Blank
Parameter blf.enhanced.parked.idle.action <y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is idle and a call is parked
against the monitored phone.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.parked.idle.action = newcall
Note: It works only if “blf.enhanced.parked.enable” is set to 1 (Enabled). It is not applicable to T19(P)
E2/CP920 IP phones.
Permitted
Values
String
Default Blank