Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
58
RPC Method Description
Upload
This method is used to cause the CPE to upload a specified file to the designated location.
File types supported by IP phones are:
l Configuration File
l Log File
ScheduleInform
This method is used to request the CPE to schedule a one-time Inform method call (separate
from its periodic Inform method calls) sometime in the future.
FactoryReset This method resets the CPE to its factory default state.
TransferComplete
This method informs the ACS of the completion (either successful or unsuccessful) of a file
transfer initiated by an earlier Download or Upload method call.
AddObject This method is used to add a new instance of an object defined on the CPE.
DeleteObject This method is used to remove a particular instance of an object.
TR069 Configuration
The following table lists the parameters you can use to configure TR069.
Parameter static.managementserver.enable <y0000000000xx>.cfg
Description It enables or disables the TR069 feature.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Web UI Settings->TR069->Enable TR069
Parameter static.managementserver.username <y0000000000xx>.cfg
Description
It configures the user name for the IP phone to authenticate with the ACS (Auto Configuration Servers).
Leave it blank if no authentication is required.
Example:
static.managementserver.username = tr69
Permitted
Values
String within 128 characters
Default Blank
Web UI Settings->TR069->ACS Username
Parameter static.managementserver.password <y0000000000xx>.cfg
Description
It configures the password for the IP phone to authenticate with the ACS (Auto Configuration Servers).
Leave it blank if no authentication is required.
Example:
static.managementserver.password = tr69
Permitted
Values
String within 64 characters
To Next Page
Loading...
