Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
136
5-Null
Default 0
Web UI Settings->Call Display->Call Information Display Method
Parameter phone_setting.call_display_name.mode <y0000000000xx>.cfg
Description
It specifies which display names to be used as the caller ID/callee ID for calls from/to contacts in the
phone directory.
Note: This parameter also affects history records display. It is not applicable to
T48G/T46G/T42G/T41P/T29G IP phones.
Permitted
Values
0-Names matched to the entries in the following phone directories are displayed preferentially, the pri-
ority is as follows: Local Directory>Remote Phone Book>Broadsoft Network Directory>BroadCloud Bud-
dies>LDAP Directory>Network signaling.
1-Names provided through network signaling are displayed preferentially.
Default 0
Parameter phone_setting.incoming_call.horizontal_roll_interval <y0000000000xx>.cfg
Description
It configures the interval (in milliseconds) for the IP phone to horizontally scroll the caller information
when the phone is ringing.
Note: It is not applicable to CP920 IP phones.
Permitted
Values
Integer from 100 to 2000
Default 500
Parameter
account.X.update_ack_while_dialing
[1]
<MAC>.cfg
Description It enables or disables the IP phone to update the display of call ID according to the ACK message.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Parameter
account.X.refresh_remote_id.enable
[1]
<MAC>.cfg
Description
It enables or disables the IP phone to update the identity of the caller according to the request message
from the remote party.
Permitted
Values
0-Disabled
1-Enabled
Default 1
Parameter
sip.disp_incall_to_info
[2]
<y0000000000xx>.cfg
Description
It enables or disables the phone to display the identity contained in the To field of the INVITE message
when it receives an incoming call.
Permitted
Values
0-Disabled
1-Enabled
Default 0
To Next Page
Loading...
