Call Features
275
Description It configures the account to be used to retrieve E911 location information.
Permitted
Values
T54S/T48S/T48G/T46S/T46G/T29G: Integer from 1 to 16;
T52S/T42S/T42G: Integer from 1 to 12;
T41P/T41S/T27G: Integer from 1 to 6;
T40P/T40G/T23P/T23G: Integer from 1 to 3;
T21(P) E2: Integer from 1 to 2;
T19(P) E2/CP920: 1.
Default 1
Parameter dialplan.emergency.custom_asserted_id <y0000000000xx>.cfg
Description
It configures the custom outbound identity when placing an emergency call.
Note: It works only if “dialplan.emergency.enable” is set to 1 (Enabled) and “dialplan.emergency.asserted_
id_source” is not set to HELD.
Permitted
Values
10-25 digits - for example, 1234567890. The SIP URI constructed from the number and SIP server (for
example, abc.com) is included in the P-Asserted-Identity (PAI) header (for example, <sip:1234567890@-
abc.com>).
SIP URI - for example, sip:1234567890123@abc.com. The full URI is included in the P-Asserted-Identity
(PAI) header and the address will be replaced by the emergency server (for example,
<sip:1234567890123@emergency.com>).
TEL URI - for example, tel:+16045558000. The full URI is included in the P-Asserted-Identity (PAI) header
(for example, <tel:+16045558000>).
Default Blank
Parameter
dialplan.emergency.server.X.address
[1]
<y0000000000xx>.cfg
Description
It configures the IP address or domain name of the emergency server X to be used for routing calls.
Note: If the account information has been configured (no matter whether the account registration suc-
ceeds or fails), the emergency calls will be dialed using the following priority: SIP server>emergency
server; if not, the emergency server will be used. It works only if “dialplan.emergency.enable” is set to 1
(Enabled) and “dialplan.emergency.asserted_id_source” is not set to HELD.
Permitted
Values
IP address or domain name
Default Blank
Parameter
dialplan.emergency.server.X.port
[1]
<y0000000000xx>.cfg
Description
It configures the port of emergency server X to be used for routing calls.
Note: It works only if “dialplan.emergency.enable” is set to 1 (Enabled) and “dialplan.emergency.asserted_
id_source” is not set to HELD.
Permitted
Values
Integer from 1 to 65535
Default 5060
Parameter
dialplan.emergency.server.X.transport_type
[1]
<y0000000000xx>.cfg
Description It configures the transport protocol the IP phone uses to communicate with the emergency server X.
To Next Page
Loading...
