Yealink T21PE2 - Page 283

Call Features
277
Values
If it is set to SIMPLE, the IP phone will send the location request message defined in RFC5985.
If it is set to REDSKY, the IP phone will send the location request message defined by REDSKY.
Default SIMPLE
Parameter
dialplan.emergency.held.request_element.X.name
[1]
<y0000000000xx>.cfg
Description
It configures the custom element name to be sent in a location request message.
For example:
dialplan.emergency.held.request_element.1.name = mac
dialplan.emergency.held.request_element.2.name = companyID
dialplan.emergency.held.request_element.3.name = nai
Note: It works only if “dialplan.emergency.enable” is set to 1 (Enabled) and “dialplan.emergency.asserted_
id_source” is set to HELD.
Permitted
Values
String
Default Blank
Parameter
dialplan.emergency.held.request_element.X.value
[2]
<y0000000000xx>.cfg
Description
It configures the custom element value to be sent in a location request message.
For example:
dialplan.emergency.held.request_element.1.value = 001565B38ECB
dialplan.emergency.held.request_element.2.value = 6f2f2d50-c385-4b72-b84a-ce0ca3a77cb7
dialplan.emergency.held.request_element.3.value = 8611@pbx.yealink.com
Note: It works only if “dialplan.emergency.enable” is set to 1 (Enabled) and “dialplan.emergency.asserted_
id_source” is set to HELD.
Permitted
Values
String
Default Blank
Parameter
account.X.reg_with_pani_header.enable
[3]
<MAC>.cfg
Description It enables or disables the IP phone to carry the PANI header in the REGISTER request message.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Parameter
account.X.invite_with_pani_header.enable
[3]
<MAC>.cfg
Description
It enables or disables the IP phone to carry the PANI header in the INVITE request message.
The PANI header format is:
P-Access-Network-Info:IEEE-802.3; eth-location=<MAC Address Of The Phone>; local-time-zone=”0800”
Permitted
Values
0-Disabled
1-Enabled