EasyManua.ls Logo

Yealink T21PE2 - Page 309

Yealink T21PE2
556 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Call Features
303
Default 1
Web UI Features->General Information->Play Hold Tone
Parameter features.play_hold_tone.delay <y0000000000xx>.cfg
Description
It configures the time (in seconds) to wait for the IP phone to play the initial call hold tone.
If it is set to 30 (30s), the IP phone will wait 30 seconds to play the initial call hold tone after you place a
call on hold.
Note: It works only if features.play_hold_tone.enable is set to 1 (Enabled).
Permitted
Values
Integer from 3 to 3600
Default 30
Web UI Features->General Information->Play Hold Tone Delay
Parameter features.play_hold_tone.interval <y0000000000xx>.cfg
Description
It configures the time (in seconds) between subsequent call hold tones.
If it is set to 3 (3s) and features.play_hold_tone.delay” is set to 30 (30s), the IP phone will begin to play a
hold tone after you place a call on hold for 30 seconds, and repeat the call hold tone every 3 seconds.
Note: It works only if features.play_hold_tone.enable is set to 1 (Enabled).
Permitted
Values
Integer from 3 to 3600
Default 30
Web UI Features->General Information->Hold Tone Interval(second)
Parameter features.play_held_tone.enable <y0000000000xx>.cfg
Description It enables or disables the IP phone to play the call held tone when a call is held by the other party.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Web UI Features->General Information->Play Held Tone
Parameter features.play_held_tone.delay <y0000000000xx>.cfg
Description
It configures the time (in seconds) to wait for the IP phone to play the initial call held tone.
If it is set to 30 (30s), the IP phone will wait 30 seconds to play the initial call held tone after you are held
by the other party.
Note: It works only if the Music on Hold feature is disabled and “features.play_held_tone.enable” is set to
1 (Enabled).
Permitted
Values
Integer from 3 to 3600
Default 30
Web UI Features->General Information->Play Held Tone Delay
Parameter features.play_held_tone.interval <y0000000000xx>.cfg
Description It configures the time (in seconds) between subsequent call held tones.

Table of Contents

Related product manuals