Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
328
the one with a lower priority.
Default 1
Web UI Directory->Multicast IP->Paging Priority Active
Parameter multicast.receive_priority.priority <y0000000000xx>.cfg
Description
It configures the priority of the voice call (a normal phone call rather than a multicast paging call) in pro-
gress.
1 is the highest priority, 31 is the lowest priority.
Permitted
Values
0-Disabled, all incoming multicast paging calls will be automatically ignored when a voice call is in pro-
gress.
1-1
2-2
3-3
...
31-31
If it is set to other values, the IP phone will receive the incoming multicast paging call with a higher or
equal priority and ignore the one with a lower priority when a voice call is in progress.
Default 31
Web UI Directory->Multicast IP->Paging Barge
Parameter multicast.receive.ignore_dnd.priority <y0000000000xx>.cfg
Description
It configures the lowest priority of the multicast paging call that can be received when DND is activated in
phone mode.
1 is the highest priority, 31 is the lowest priority.
Note: It is not applicable to CP920 IP phones.
Permitted
Values
0-Disabled, all incoming multicast paging calls will be automatically ignored when DND is activated in
phone mode.
1-1
2-2
3-3
...
31-31
If it is not set to 0 (Disabled), the IP phone will receive the incoming multicast paging call with a higher or
same priority than this value and ignore that with a lower priority than this value when DND is activated
in phone mode.
Default 0
Web UI Directory->Multicast IP->Ignore DND
Parameter
multicast.listen_address.X.volume
[1]
<y0000000000xx>.cfg
Description It configures the volume of the speaker when receiving the multicast paging calls.
To Next Page
Loading...
