Yealink T21PE2 - Page 352

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
346
Note: It works only if “voice.tone.country” is set to Custom.
Permitted
Values
String
Default Blank
Web UI Settings->Tones->Dial
Parameter
features.partition_tone
[1]
<y0000000000xx>.cfg
Description
It enables or disables the IP phone to play the different dial tones when there is no active account.
Note: It works only if “voice.tone.dial” is configured.
Permitted
Values
0-Disabled
1-Enabled. If there is an active account, the IP phone will play the default dial tone. If there is no active
account, the IP phone will play the dial tone configured by “voice.tone.dial”.
Default 0
Parameter voice.tone.secondary_dial <y0000000000xx>.cfg
Description
It customizes the secondary dial tone.
The value format is Freq/Duration. For more information on the value format, refer to the parameter
“voice.tone.dial”.
Note: It works only if “voice.tone.country” is set to Custom. If you want to disable this warning tone, set it
to 0.
Permitted
Values
String
Default 350+440/3000
Web UI Settings->Tones->Secondary Dial
Parameter voice.tone.ring <y0000000000xx>.cfg
Description
It customizes the ringback tone.
The value format is Freq/Duration. For more information on the value format, refer to the parameter
“voice.tone.dial”.
Note: It works only if “voice.tone.country” is set to Custom. If you want to disable this warning tone, set it
to 0.
Permitted
Values
String
Default Blank
Web UI Settings->Tones->Ring Back
Parameter voice.tone.busy <y0000000000xx>.cfg
Description
It customizes the tone when the callee is busy.
The value format is Freq/Duration. For more information on the value format, refer to the parameter
“voice.tone.dial”.
Note: It works only if “voice.tone.country” is set to Custom. If you want to disable this warning tone, set it
to 0.
Permitted
String