Yealink T21PE2 - Page 358

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
352
Example:
account.1.codec.g722.enable = 1
Note: The name of the audio codec in this parameter should be the correct one as listed in the above
example, otherwise the corresponding configuration will not take effect.
Permitted
Values
0-Disabled
1-Enabled
Default
Default:
When the audio codec is G.722.1c,(48kb/s), the default value is 1;
When the audio codec is G.722.1c,(32kb/s), the default value is 1;
When the audio codec is G.722.1c,(24kb/s), the default value is 1;
When the audio codec is G.722.1,(48kb/s), the default value is 1;
When the audio codec is G722, the default value is 1;
When the audio codec is PCMU, the default value is 1;
When the audio codec is PCMA, the default value is 1;
When the audio codec is G729, the default value is 1;
When the audio codec is G726-16, the default value is 0;
When the audio codec is G726-24, the default value is 0;
When the audio codec is G726-32, the default value is 0;
When the audio codec is G726-40, the default value is 0;
When the audio codec is G723_53, the default value is 0;
When the audio codec is G723_63, the default value is 0;
When the audio codec is Opus, the default value is 0;
When the audio codec is iLBC_15_2kbps, the default value is 0;
When the audio codec is iLBC_13_33kpbs, the default value is 0;
Web UI Account->Codec->Audio Codec
Parameter
account.X.codec.<payload_type>.priority
[1]
<MAC>.cfg
Description
It configures the priority of the enabled audio codec.
The name of the audio codec:
g722_1c_48kpbs-G.722.1c,(48kb/s)
g722_1c_32kpbs-G.722.1c,(32kb/s)
g722_1c_24kpbs-G.722.1c,(24kb/s)
g722_1_24kpbs-G.722.1,(24kb/s)
g722-G722
pcmu-PCMU
pcma-PCMA