EasyManua.ls Logo

Yealink T21PE2 - Page 41

Yealink T21PE2
556 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Phone Network
35
Menu->Advanced (default password: admin) ->Network->CDP->CDP Status
T42G/T42S/T41P/T41S/T40P/T40G/T27G/T23P/T23G/T21(P) E2/T19(P) E2/CP920:
Menu->Settings->Advanced Settings (default password: admin) ->Network->CDP->CDP Status
Parameter
static.network.cdp.packet_interval
[1]
<y0000000000xx>.cfg
Description
It configures the interval (in seconds) at which the IP phone sends the CDP (Cisco Discovery Protocol)
request.
Note: It works only if static.network.cdp.enable” is set to 1 (Enabled).
Permitted
Values
Integer from 1 to 3600
Default 60
Web UI Network->Advanced->CDP->Packet Interval (1~3600s)
Phone UI
T54S/T52S/T48S/T48G/T46S/T46G/T29G:
Menu->Advanced (default password: admin) ->Network->CDP->CDP Interval
T42G/T42S/T41P/T41S/T40P/T40G/T27G/T23P/T23G/T21(P) E2/T19(P) E2/CP920:
Menu->Settings->Advanced Settings (default password: admin) ->Network->CDP->CDP Interval
[1]If you change this parameter, the IP phone will reboot to make the change take effect.
Manual VLAN Configuration
VLAN is disabled on IP phones by default. You can configure VLAN for the Internet port and PC port manually. For
CP920 IP phones, you can only configure VLAN for the Internet port manually, because they only have Internet port.
Before configuring VLAN on the IP phone, you need to obtain the VLAN ID from your network administrator.
The following table lists the parameters you can use to configure VLAN manually.
Parameter
static.network.vlan.internet_port_enable
[1]
<y0000000000xx>.cfg
Description It enables or disables the VLAN for the Internet port.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Web UI Network->Advanced->VLAN->WAN Port->Active
Phone UI
T54S/T52S/T48S/T48G/T46S/T46G/T29G:
Menu->Advanced (default password: admin) ->Network->VLAN->WAN Port->VLAN Status
T42G/T42S/T41P/T41S/T40P/T40G/T27G/T23P/T23G/T21(P) E2/T19(P) E2/CP920:
Menu->Settings->Advanced Settings (default password: admin) ->Network->VLAN->WAN Port->VLAN
Status
Parameter
static.network.vlan.internet_port_vid
[1]
<y0000000000xx>.cfg
Description
It configures the VLAN ID for the Internet port.
Note: It works only if static.network.vlan.internet_port_enable” is set to 1 (Enabled).
Permitted
Values
Integer from 1 to 4094

Table of Contents

Related product manuals