Yealink T21PE2 - Page 508

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
502
Values
Default Personal
Web UI Applications->Broadsoft XSI->Network Directory->Personal (if bw.enable =1)
Parameter directory.update_time_interval <y0000000000xx>.cfg
Description
It configures the interval (in minutes) for the IP phone to update the data of the BroadSoft directory from
the BroadSoft server.
Note: It works only if “bw.xsi.directory.enable” and “bw.xsi.directory.update.enable” are set to 1
(Enabled).
Permitted
Values
Integer from 60 to 34560
Default 60
Parameter bw.xsi.directory.update.enable <y0000000000xx>.cfg
Description
It enables or disables the IP phone to automatically download all contacts in the BroadSoft Directory from
the server.
Note: It works only if “bw.xsi.directory.enable” is set to 1 (Enabled).
Permitted
Values
0-Disabled, the IP phone downloads partial contacts from the server (the maximum of contacts available
for viewing at one time is determined by the server), and you can manually download the remaining con-
tacts as needed.
1-Enabled
Default 1
Parameter bw_phonebook.group_common_displayname <y0000000000xx>.cfg
Description
It configures the display name on the phone screen for the group common directory.
Note: It works only if "bw.xsi.enable", "bw.xsi.directory.enable" and "bw_phonebook.group_common_
enable" are set to 1 (Enabled).
Permitted
Values
String within 99 characters
Default GroupCommon
Web UI Applications->Broadsoft XSI->Network Directory->Group Common (if bw.enable =1)
Parameter bw.xsi.directory.alphabetized_by_lastname.enable <y0000000000xx>.cfg
Description
It configures the call ID (first name and last name) display method when the phone receives an incoming
call, places an outgoing call or is during an active call.
Note: It is not applicable to CP920 IP phones.
Permitted
Values
0-First name Last name
1-Last name, First name
Default 0
Parameter bw.calllog_and_dir <y0000000000xx>.cfg
Description
It enables or disables the IP phone to directly enter the Network Calls screen when pressing the History
soft key on the idle screen.
Note: It works only if "bw.xsi.enable" and "bw.xsi.call_log.enable" are set to 1 (Enabled).