Yealink T21PE2 - Page 57

Phone Network
51
Parameter
static.network.pc_port.enable
[1]
<y0000000000xx>.cfg
Description
It enables or disables the PC port.
Note: It is not applicable to CP920 IP phones.
Permitted
Values
0-Disabled
1-Auto Negotiation
Default 1
Web UI Network->PC Port->PC Port Active
Parameter
static.network.internet_port.speed_duplex
[1]
<y0000000000xx>.cfg
Description
It configures the transmission method of the Internet port.
Note: For T54S/T52S/T48S/T48G/T46S/T46G/T42G/T42S/T40G/T29G/T27G/T23G/CP920 IP phones, you can
set the transmission speed to 1000Mbps/Auto Negotiation to transmit in 1000Mbps if the IP phone is con-
nected to the switch supports Gigabit Ethernet. We recommend that you do not change this parameter.
Permitted
Values
0-Auto Negotiation
1-Full Duplex 10Mbps
2-Full Duplex 100Mbps
3-Half Duplex 10Mbps
4-Half Duplex 100Mbps
5-Full Duplex 1000Mbps (only applicable to
T54S/T52S/T48S/T48G/T46S/T46G/T42G/T42S/T40G/T29G/T27G/T23G/CP920 IP phones)
Default 0
Web UI Network->Advanced->Port Link->WAN Port Link
Parameter
static.network.pc_port.speed_duplex
[1]
<y0000000000xx>.cfg
Description
It configures the transmission method of the PC port.
Note: It works only if “static.network.pc_port.enable” is set to 1 (Auto Negotiation). For
T54S/T52S/T48S/T48G/T46S/T46G/T42G/T42S/T40G/T29G/T27G/T23G IP phones, you can set the trans-
mission speed to 1000Mbps/ Auto Negotiation to transmit in 1000Mbps if the IP phone is connected to
the switch supports Gigabit Ethernet. We recommend that you do not change this parameter. It is not
applicable to CP920 IP phones.
Permitted
Values
0-Auto Negotiation
1-Full Duplex 10Mbps
2-Full Duplex 100Mbps
3-Half Duplex 10Mbps
4-Half Duplex 100Mbps
5-Full Duplex 1000Mbps (only applicable to
T54S/T52S/T48S/T48G/T46S/T46G/T42G/T42S/T40G/T29G/T27G/T23G IP phones)
Default 0
Web UI Network->Advanced->Port Link->PC Port Link
Parameter
static.network.vlan.pc_port_mode
[1]
<y0000000000xx>.cfg