Chapter 3 PERFORMING MEASUREMENTS
3-62
Using the Average Measurement Continue Function
The average measurement continue function allows you to perform average measurement
on the obtained trace additionally.
For instance, if the data obtained by average measurement (2^16) contains a lot of noise,
enabling this function and starting average measurement will continue to perform average
measurement on that data up to 2^18 times. This results in shorter measurement time,
compared to that when increasing the average time and performing average measurement
from the beginning again.
The average measurement continue setting can be changed as explained below.
♦ Example: “OFF” → “ON”
•This function cannot be used for data obtained by “2^18”, “262k” or “30min”.
•This function cannot be changed if “AUTO RANGE” or “AUTO ATTENUATION”
has been selected for AUTO SET. And multi wavelength is set.
1. Display the measurement condition/auto search condition change window.
For the method of displaying the window, refer to page 3-10.
2. Locate the cursor to “AVE. CONTINUE” by using the rotary knob or the arrow
key.
3. Press [ENTER].
A selection window will appear.
*: Indicates the default setting.
TIP
*OFF Disables the average measurement continue function.
Selectable average
measurement
continue setting
ON
Enables the average measurement continue function.
Caution
Refer
To Next Page
Loading...
Need help?
General
