Chapter 3 PERFORMING MEASUREMENTS
3-63
4. Locate the cursor to “ON” by using the rotary knob or [S] / [T].
5. Press [ENTER] to register the change made to the average measurement
continue setting.
6. Press [F4] (DONE) to register the changes made to the measurement
conditions.
7. Press [AVE] to start measurement.
The average measurement continue setting will be retained in the internal memory
even if the instrument is turned OFF. So, when the instrument is turned ON, the
measurement conditions in effect immediately before the instrument was turned
OFF previously will be restored.
Averaging time or averaging interval is displayed, when measurement start.
Refer to the notes given on changing the measurement conditions (page 3-50).
Changing measurement conditions and average measurement again
•For the method of changing the measurement conditions, refer to page 3-12.
•For the method of performing average measurement, refer to page 3-56.
Caution
TIP
Refer
Refer
To Next Page
Loading...
Need help?
General
