7.
Press the Enter soft key to confirm the setting.
Setting the Default Gateway
You can only set the default gateway when DHCP is off.
5.
Press the Defalt Gatwy soft key to display the default gateway setup screen.
The NUM LOCK key illuminates, and the GS200 changes to keypad mode.
6.
Press the and keys that correspond to numbers 0 to 9 and the period to set
the default gateway.
7.
Press the Enter soft key to confirm the setting.
Setting the Transmission Terminator
5.
Press the Term soft key to display the following menu.
6.
Press the soft key that corresponds to the terminator that you want to use.
Restarting the GS200
You must restart the GS200 to apply any new or changed network settings other than the
transmission terminator setting.
Explanation
To use the GS200’s network features, you must configure the TCP/IP settings.
DHCP (Dynamic Host Configuration Protocol)
DHCP is a protocol that temporarily allocates necessary information to a computer so
that it can connect to the Internet. If DHCP is turned on, the following settings will be
automatically assigned.
•
IP
address
• Subnet mask
• Default gateway
• To use DHCP, the network must have a DHCP server. Consult your network
administrator to see if DHCP is available.
• Dif
ferent information may be assigned to the GS200 each time it is turned on. When
you are using a PC to access the GS200, you must check the GS200 IP address and
other network settings each time you turn the GS200 on.
11.3 Configuring Network Settings (TCP/IP)
To Next Page
Loading...
Need help?
General
