YOKOGAWA UT55A - Page 57

4-6
IM 05P01C31-01EN
HowtoSetParameterSetpoint
NumericValueSetting
1.
2.
3.
4.
5.
Press the Left arrow key to move one digit to the left.
(Press the Right arrow key to move one digit to the right.)
Press the Up or Down arrow key to change the setpoint.
Press the Up arrow key when 9 is displayed to move one
digit to the left.
Press the Down arrow key when 0 is displayed to move
one digit to the right.
Press the SET/ENTER key to register the setpoint.
Display the Parameter Setting Display.
Press the SET/ENTER key to move to the setting
mode (the setpoint blinks).
Selection Data Setting
1.
2.
3.
4.
Press the Up arrow key to change the setpoint (press
the Down arrow key to change the setpoint).
Press the SET/ENTER key to register the setpoint.
Display the Parameter Setting Display.
Press the SET/ENTER key to move to the setting
mode (the setpoint blinks).
4.2HowtoSetParameters