Zebra MP7000 - Page 124

4 - 6 MP7000 Scanner Scale Integrator Guide
To continue with calibration:
1. Depending on the units of measure programmed, place 25 lb or 11 kg on the scale. Ideally these weights
should be grouped in the center of the scale (
Figure 4-2).
Figure 4-2 (A) Center of Scale Location, and (B) Center of Scale Location with Platter Installed
a. Place 25 lb weights on the scanner as shown in Figure 4-3; three 5 lb weights centered on the center of the
scale, and two 5 lb weights centered on top.
Figure 4-3 Weight Calibration Configuration for Pounds
A
Center of
Scale
B
Center of Scale
5 lb. 5 lb. 5 lb.
5 lb. 5 lb.