4 - 24 MP7000 Scanner Scale Integrator Guide
Successfully
entering scale
legal Calibration
Mode
Step 3 - Program
Legal Parameters
and
Step 4 -
Calibration at NO
LOAD
- Scrolls
C00Lb
OR
C00g
depending on units
programmed as
pounds (lb) or
kilograms (kg)
Step 5 - Calibration at
LOAD
- Scrolls
C25Lb
or
C11g
depending on units
programmed as
pounds (lb) or
kilograms (kg)
Step 6 - Calibration
Success or Failure
-
Repeat scrolls of
CALP
then
CALS
Any step - Calibration
Fails - Scrolls fault
code:
u##
No change Five long beep
tones
Off
Step 4 - Calibration at NO
LOAD
Blinks between CAL00 and
then CAL_ _ with correct
unit icon illuminated (lb or
kg).
Step 5 - Calibration at
LOAD
Blinks CAL25 with lb icon
illuminated, or blinks CAL11
with kg icon illuminated.
Step 6 - Calibration
Success or Failure
Blinks between CAL P
(PASS) and CAL S (save
legal parameter settings).
Any step - Calibration fails
blinks CAL F.
Between
calibration steps
No change No change No change Off Blinks HOLD while taking a
measurement.
Stepping through
a calibration step
No change No change Single long beep
tone after
pressing the
Scale Zero
button
Off No change
Failure to place
the correct load
on the scale at
Step 5 -
Calibration at
LOAD
C25Lb
or
C11g
depending on units
programmed
No change Two long beep
tones
No change No change
Successfully
executing and
exiting a scale
legal calibration
Calibration procedure
semantics removed
from display.
No change Three short
beeps
Solid green
on if weight
stable after
reset of
scale
Scale is reset either by
pressing the
Scale Zero
button, scanning the
Scale
Reset
parameter barcode,
or powering the unit OFF
then ON. The seven
segment test will run.
Table 4-6 LED and Beeper Sequences (Continued)
Scale State
7-segment
Diagnostic Display
LED
(System)
Beeper
Sequence
Scale Zero
Button
(LED)
Optional Scale Display
To Next Page
Loading...