GDP-32II INSTRUCTION MANUAL
May 2002 Section 2, Page 14
Home
SELECT UP
,
SELECT DN
End
- Parameters contained in certain fields have a set number of pre-
selected values. These values are contained in a “Rotary Table” and are accessed by
using the select keys. Note that these keys do not move the cursor but only select a value
found in the rotary table. An example of using these keys would be selecting frequency
and cycle count in binary increments, or stepping through the choices for line designation
in menu 2: N, E, S, W, NE, SE, SW, NW. These keys are also used to page through the
data and calibrate cache, one block or one frequency at a time.
11. Control Keys
This group contains frequently used keys that control the operation of the receiver.
Enter
– Locks in parameters in the current screen and moves to the next screen or
engages a function after all parameters have been set.
Escape
– Used to terminate data collection before the full number of stacks have been
acquired.
– Used to double the function of certain panel keys. This key is latched, so it is
not necessary to hold it down while pressing the second key.
To Next Page
