MAINTENANCE
Section 17, Page 11 May 2002
16. Press
Pg Dn
NEXT FIELD
to get to the second gain stage. Use
Home
SELECT UP
or
SELECT DN
End
to change it to 1.
At this point you can now adjust the gains and DAC (SP) to watch the effect on the
meter.
It is a good idea for operators to become familiar with the Diagnostic Program. These routines
provide added insight into the operation of the timing and calibration board and analog boards.
Clients may be required to access the Diagnostics Program to facilitate trouble-shooting over
the telephone.
If you have any questions concerning this program, please do not hesitate to contact our office.
To Next Page
