GDP-32
II
INSTRUCTION MANUAL
May 2002 Section 5, Page 8
OPERATOR INFORMATION SCREEN
Semi-permanent survey information is entered into the Operator Information Screen. This
information will be changed infrequently and makes up header text preceding data in the Field
Data Cache. (The RPIP Survey Program is used as the example for this discussion.)
User Programmable Fields
OPER (Operator)
User defined identification number
(alphanumeric), up to nine characters.
TX ID (Transmitter ID)
Serial Number of the transmitter or any
user defined identification number
(alphanumeric), up to four characters.
A-SP (A-Spacing)
The Dipole size (in meters or feet), up to
six digits.
JOB (Job ID)
User defined identification number
(alphanumeric), up to 5 digits.
LINE
User defined identification number. Two
fields are available:
1. Alphanumeric designator (e.g. xxxxx.x) that defines the line, up to eight
characters
2. Directional designator: N, E, S, W, NE, SE, SW, or NW.
SPREAD
User defined identification number, subdivision of the LINE designator (alphanumeric), up to
two characters.
Additional Options
Press to temporarily exit data acquisition and look at data in the Field Data
Cache. See Section 7- Handling Data, for information about Data Mode.
Press
Enter
to proceed to the next menu.
Press
Escape
to return to the previous menu.
0810 RPIP0612 11.8 19 Jan 00 14:32:19
OPER dbf TX ID 1234 A-SP 6
JOB 94001 LINE 1 N SPREAD 1
CH N
1ON1
2ON2
3OFF
4OFF
CONTINUE: Next menu, ESCAPE: Prev. menu
To Next Page
Loading...
