ABB ACL30 - Page 102

102 Using the control panel
6. Press . The current value of the bit pointer
parameter is shown, as well as the parameter
group it points to.
7. Specify a new parameter group for the bit pointer
parameter to point to with keys and
. The parameter group changes
respectively.
8. • To continue, press .
• To cancel the new value and keep the original,
press .
Specify a new parameter for the bit pointer
parameter to point to with keys and
. The parameter name changes
respectively.
9. • To continue, press .
• To cancel the new value and keep the original,
press .
Specify a new bit for the bit pointer parameter to
point to with keys and . The bit
number and name (if defined) change respectively.
Here bit 00 stands for bit number 2
0
= 1, the first
bit from the right in a 32-bit signal.
10. • To save the new value for the bit pointer
parameter, press .
• To cancel the new value and keep the original,
press .
The new value is shown in the parameters list.
Step Action Display
NEXT
1204 DI01 OUT PTR
PAR EDIT
P.01.01.00
CANCEL NEXT00:00
01 ACTUAL VALUES
LOC
1204 DI01 OUT PTR
PAR EDIT
P.06.01.00
CANCEL NEXT
00:00
06 DRIVE STATUS
LOC
NEXT
CANCEL
1204 DI01 OUT PTR
PAR EDIT
P.06.01.00
CANCEL NEXT00:00
0601 STATUS WORD 1
LOC
NEXT
CANCEL
1204 DI01 OUT PTR
PAR EDIT
P.06.01.00
CANCEL SAVE00:00
00 READY
LOC
SAVE
CANCEL
1201 DI01 CONF9901
1202 DI02 CONF
1203 DI03 CONF
1204 DI01 OUT PTR
P.06.01.00
PARAMETERS
EXIT
EDIT00:00
LOC