ABB ACL30 User Manual

118 Using the control panel
 Loading a user set between different firmware versions
If you try load a user set between different firmware versions, the panel shows you
the following fault information:
Step Action Display
1. Go to the Parameters option by selecting
PARAMETERS on the main menu as shown in
section Using the Parameters option on page 97.
A user set is loaded through parameter 16.07
USER SET SEL. Select parameter group 16
SYSTEM with keys and .
2. Press to select the parameter group 16.
Select parameter 16.07 USER SET SEL with keys
and . The current value of each
parameter is shown below its name.
3. Press .
Select the user set you want to load with keys
and .
Press .
4. Panel shows a text identifying the fault.
EXIT SEL
00:00
10 START/STOP
12 DIGITAL IO
13 ANALOGUE INPUTS
15 ANALOGUE OUTPUTS
16 SYSTEM
PAR GROUPS 16
LOC
SEL
1604 PASS RESTORE
1605 PARAM SAVE
1606 PARAM CLEAR
1607 USER SET SEL
No request
PARAMETERS
EXIT
EDIT00:00
LOC
EDIT
1607 USER SET SEL
PAR EDIT
No request
CANCEL SAVE00:00
[1]
LOC
SAVE
1607 USER SET SEL
PAR EDIT
Load set 1
CANCEL SAVE00:00
[2]
LOC
FAULT 310
USERSET LOAD
FAULT
RESET
EXIT
LOC

ABB ACL30 Specifications

General

Brand	ABB
Model	ACL30
Category	DC Drives
Language	English