Program features 131
Parameter restore
Parameters are divided into three different groups that can be restored together or
individually:
• Motor configuration parameters and identification (ID) run results
• Encoder and fieldbus adapter settings
• Other parameters.
For example, retaining the existing ID run results in the drive makes a new ID run
unnecessary.
Restoring individual parameters can fail for the following reasons:
• The restored value does not fall within the minimum and maximum limits of the
drive parameter
• The type of the restored parameter is different from that in the drive
• The restored parameter does not exist in the drive (often the case when restoring
the parameters of a new firmware version to a drive with an older version)
• The backup does not contain a value for the drive parameter (often the case when
restoring the parameters of an old firmware version to a drive with a newer
version).
In these cases, the parameter is not restored. The backup/restore tool warns the user
and offers a possibility to set the parameter manually.
User parameter sets
The drive has 50 user parameter sets that can be saved to the permanent memory
and recalled using drive parameters. It is also possible to use digital inputs to switch
between different user parameter sets. See the descriptions of parameters
16.07…16.10.
A user parameter set contains all values of parameter groups 10 to 99 (except the
fieldbus communication configuration settings).
As the motor settings are included in the user parameter sets, make sure the settings
correspond to the motor used in the application before recalling a user set.
To Next Page
Loading...
Need help?
General
