Using the control panel 93
Finding panel version – any mode
Step Action Display
1. Switch Off the power, if it is switched On.
• If the panel cable can be disconnected easily,
unplug the cable from the control panel
or
• If the panel cable cannot be disconnected easily,
switch Off the drive control unit.
2. Keep key pressed down while you switch On
the power and read the information. The display
shows the following panel information:
Panel SW: Panel firmware version
ROM CRC: Panel ROM check sum
Flash Rev: Flash content version
Flash content comment.
When you release the key, the panel goes to
the Output mode.
Panel SW: x.xx
ROM CRC: xxxxxxxxxx
Flash Rev: x.xx
xxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxx
PANEL VERSION INFO
To Next Page
Loading...
Need help?
General
