ABB ACL30 - Start-up and Control

Start-up and control 77
8
Start-up and control
Contents of this chapter
This chapter contains the basic tasks to start up an ACL30 elevator drive.
A minimum set of elevator control functions required for operating an elevator is
included. You can start-up the drive from the control panel or with the DriveStudio PC
tool program. The start-up procedures presented below uses the control panel.
For detailed instructions on using the panel, see chapter Using the control panel on
page 87. For instructions on using DriveStudio, see DriveStudio user’s manual
(3AFE68749026 [English]).