ABB ACL30 - Backup and restore parameters

112 Using the control panel
 Backup and restore parameters
For all backup and restore functions available, see page 111.
Step Action Display
1. Go to the Main menu by pressing if you are
in the Output mode, otherwise by pressing
repeatedly until you get to the Main menu.
2. Go to the Parameter Backup option by selecting
PAR BACKUP on the menu with keys and
, and pressing .
3. To copy all parameters (including user sets and
internal parameters) from the drive to the control
panel, select MAKE BACKUP TO PANEL on the
Par Backup with keys and , and
press . Operation starts. Press if you
want to stop the operation.
After the backup is completed, the display shows a
message about the completion. Press to
return to the Par Backup.
4. To perform restore functions, select the
appropriate operation
(here RESTORE PARS ALL
is used as an example) on the Par Backup with
keys and .
• Press . Restoring starts.
MENU
EXIT
FAULT LOGGER
TIME & DATE
PAR BACKUP
EXIT ENTER00:00
MAIN MENU 4
LOC
ENTER
MAKE BACKUP TO PANEL
SHOW BACKUP INFO
RESTORE PARS ALL
RESTORE PARS NO-IDRUN
RESTORE PARS IDRUN
EXIT
SEL00:00
PAR BACKUP 1LOC
SEL
ABORT
ABORT
PAR BACKUP
LOC
Copying file 1/2
00:00
OK
OK
Parameter upload
successful
MESSAGELOC
00:00
MAKE BACKUP TO PANEL
SHOW BACKUP INFO
RESTORE PARS ALL
RESTORE PARS NO-IDRUN
RESTORE PARS IDRUN
EXIT
SEL
PAR BACKUP 3
LOC
00:00
SEL
Initializing param.
restore operation
PAR BACKUP
LOC
00:00