46 Mechanical installation
Installing the drive
You can mount the drive directly on the wall,
1. Mark the locations for the four holes. The mounting points are shown in
Dimension drawings.
2. Fix the screws or bolts to the marked locations.
3. Position the drive onto the screws on the surface.
Note: Lift the drive only by its chassis.
4. Tighten the screws.
Installing mains choke
See chapter Mains chokes on page 335.
Installing EMC filter
See chapter EMC filters on page 339.
Installing brake resistor
See chapter Resistor braking on page 343.
To Next Page
Loading...
