Mechanical installation 43
Mechanical installation
Contents of this chapter
The chapter describes the mechanical installation procedure of the drive.
Checking the installation site
Before installation check the installation site according to the requirements below.
Required tools
To install the drive mechanically, you need the following tools:
• drill with suitable bits
• screwdriver and/or wrench with a set of suitable bits (as appropriate for the
installation hardware used)
• tape measure, if you will not use the provided mounting template.
Check that...
The frame details are according to the Dimension drawings (from page 347)
The allowed operating conditions of the drive matches the information in
Technical
data.
The drive is mounted in the upright position.
The wall on which the drive is to be mounted on is as even as possible.
The drive mounting area is of non-flammable material.
The drive mounting material is strong enough to carry the weight of the drive.
The floor/material below the drive is non-flammable.
To Next Page
Loading...
Need help?
General
