No. Use
1 Status LED – Green for normal operation.
2 LCD display – Divided into three main areas:
• 2a: Status line – variable, depending on the mode of
operation, see section Status line on page 89.
• 2b: Center – variable; in general, shows signal and
parameter values, menus or lists. Shows also faults
and alarms.
• 2c: Bottom line – shows current functions of the two
soft keys and, if enabled, the clock display.
3 Soft key 1 – Function depends on the context. The text
in the lower left corner of the LCD display indicates the
function.
4 Soft key 2 – Function depends on the context. The text
in the lower right corner of the LCD display indicates the
function.
5 Up –
• Scrolls up through a menu or list displayed in the
center of the LCD display.
• Increments a value if a parameter is selected.
• Increments the reference value if the upper right
corner is highlighted.
• Holding the key down changes the value faster.
6 Down –
• Scrolls down through a menu or list displayed in the
center of the LCD display.
• Decrements a value if a parameter is selected.
• Decrements the reference value if the upper right
corner is highlighted.
• Holding the key down changes the value faster.
7 LOC/REM – Changes between local and remote control
of the drive.
8 Help – Displays context sensitive information when the
key is pressed. The information displayed describes the
item currently highlighted in the center of the display.
9 STOP – Stops the drive in local control.
10 START – Starts the drive in local control.
To Next Page
Loading...
Need help?
General
