ABB ACL30 - I;O Settings; Editing Parameter Settings of I;O Terminals

120 Using the control panel
I/O Settings
In the I/O Settings mode, you can:
• check the parameter settings related to any I/O terminal
• edit the parameter setting
• start, stop, change the direction and switch between local and remote control.
 Editing parameter settings of I/O terminals
Step Action Display
1. Go to the Main menu by pressing if you are
in the Output mode, otherwise by pressing
repeatedly until you get to the Main menu.
2. Go the I/O Settings mode by selecting I/O
SETTINGS on the menu with keys and
, and pressing .
Select the I/O group, e.g. Digital inputs, with keys
and .
3. Press . After a brief pause, the display shows
the current settings for the selection.
You can scroll digital inputs and parameters with
keys and .
4. Press . The panel shows information related
to I/O selected (in this case, DI1).
You can scroll information with keys and
.
Press to return to the digital inputs.
MENU
EXIT
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT ENTER00:00
MAIN MENU 1LOC
ENTER
Analog outputs
Analog inputs
Digital I/Os
Digital inputs
Relay outputs
EXIT
SEL00:00
I/O SETTINGS 1
LOC
Analog outputs
Analog inputs
Digital I/Os
Digital inputs
Relay outputs
EXIT
SEL00:00
I/O SETTINGS 4LOC
SEL
DI1
1002 UP COMMAND
DI2
DI3
I/O SETTINGS 1
LOC
EXIT
INFO
00:00
INFO
EXIT
LOC
EXIT
00:00
LOC
NUM OF I/O ITEMS
0
SLOT NUMBER
0
NODE NUMBER
I/O INFO