About the manual 23
Installation checklist contains a list for checking the mechanical and electrical
installation of the drive.
Start-up and control refers to the start-up instructions of the drive.
Using the control panel describes the control panel of the drive.
Program features contains descriptions of drive features.
Parameters describes the drive parameters.
Fault tracing lists the alarm and fault messages with possible causes and remedies.
Maintenance lists periodic maintenance actions along with work instructions.
Technical data contains the technical specifications of the drive, e.g. drive
specifications, drive sizes, technical requirements and provisions for fulfilling the
requirements of CE and other compliance markings.
The Safe torque off function describes the Safe torque off (STO) function.
Mains chokes details the optional mains chokes available for the drive.
EMC filters details the EMC filtering options available for the drive.
Resistor braking describes how to select, protect and wire brake resistors.
Dimension drawings contains the dimensional drawings of the drive and the
connected equipment.
Terms and abbreviations
Term/
abbreviation
Definition
AI Analog Input. Interface for analog input signals.
AO Analog Output. Interface for analog output signals.
CHK-xx Series of optional mains chokes
CRC Cyclic Redundancy Check
DIO Digital Input/Output. Interface for digital input/output signals.
DTC Direct Torque Control. The motor control of the frequency converter is based
on Direct Torque Control.
EFB Embedded fieldbus
Elevator
operation mode
Normal travel mode, releveling mode, evacuation mode or inspection mode
EMC Electromagnetic compatibility
FCAN-01 Optional CANopen adapter module
FDNA-01 Optional DeviceNet adapter module
FECA-01 Optional EtherCAT
®
adapter module
FENA-11 Optional Ethernet adapter module. Supports the Ethernet/IP, Modbus/TCP
and PROFINET IO protocols
To Next Page
Loading...
Need help?
General
