Electrical installation 61
Electrical installation
Contents of this chapter
The chapter describes the electrical installation procedure of the drive.
WARNING! Only qualified electricians are allowed to do the work described
in this chapter. Obey the instruction in chapter Safety instructions on
page 13. If you ignore them, injury or death, or damage to the equipment
can occur.
Make sure the drive is disconnected from input power during installation. If the
drive is already connected to the input power, wait for 5 minutes after
disconnecting the input power.
WARNING! The installation must always be designed and made according
to applicable local laws and regulations. ABB does not assume any liability
whatsoever for any installation that breaches the local laws and/or other
regulations.
If recommendations given by ABB are not followed, the drive system may
experience problems that the warranty does not cover.
To Next Page
Loading...
