Safety instructions 19
General safety in operation
These instructions are for all personnel that operate the drive.
WARNING! Obey these instructions. If you ignore them, injury or death, or
damage to the equipment can occur.
• Do not control the motor with the disconnector at the drive power supply; instead,
use the control panel start and stop keys or commands through the I/O terminals
of the drive.
• Give a stop command to the drive before you reset a fault. If you have an external
source for the start command and the start is on, the drive will start immediately
after the fault reset.
Note: When the control location is not set to Local, the stop key on the control panel
will not stop the drive.
To Next Page
Loading...
