About the manual 27
Check the insulation of the supply cable, the
motor and the motor cable, and the resistor cable
(if present).
Electrical installation: Checking the
insulation of the assembly (page 62)
If the drive is connected to an IT (ungrounded)
system, disconnect the internal varistors and
EMC filters.
Note: Do not use an EMC filter in an IT
(ungrounded) system.
Safety instructions: Safety in installation,
start-up and maintenance (page 18)
Electrical installation: Connecting the
power cables (page 64)
Connect the power cables.
Connect the control and the auxiliary control
cables.
Electrical installation: Connecting the
power cables (page 64) and Connecting
the control cables: JCU control unit
(page 70)
For optional equipment, see:
Mains chokes (page 335)
EMC filters (page 339)
Resistor braking (page 343)
See also, manuals for any optional
equipment
Check the installation. Installation checklist (page 75)
Commission the drive. Start-up and control (page 77)
Commission the brake chopper if required. Resistor braking (page 343)
Operate of the drive: start, stop, speed control
etc.
Start-up the drive (page 78)
Task See...
To Next Page
Loading...
Need help?
General
