Order Entry
AEROSET
®
Customer Training Guide 4-7
94858-103 — July 2003
Host Order Query
The AEROSET System can also be configured for Host Order Query.
This feature allows the AEROSET System to query the Host computer
for the tests to run on a sample when the AEROSET System encounters
the sample and identifies it by reading a bar code.
If the AEROSET System is configured for Host Order Query, the
Operator loads the bar code labeled samples and initiates a run. The
AEROSET System scans the bar code and determines it lacks an order
for the sample, then sends a message to the Host requesting the order.
The AEROSET System waits for the Host to reply and runs the sample,
when the order is received.
NOTE: Configuring the AEROSET System for downloading or
Host Order Query is discussed in Module 8, Configuration.
• Reads 5, 4, 3, 2, 1 and does 5 orders
at a time.
To Next Page
Loading...