Assay Configuration
AEROSET
®
Customer Training Guide 8-31
94858-103 — July 2003
Calibrator/Control Configuration
• Calibrators are defined in positions on the Calibrator/Control
Carousel or in the Sample Carousel.
• Controls can only be configured in the Calibrator/Control
Carousel.
• The calibrator or control name and the target values are defined in
the CALIBRATOR/CONTROL screen accessed by selecting
<Cal/Control> from the Information Access Area.
NOTE: If creating a new assay, calibrator and control
targets cannot be configured until the assay parameter
configuration is complete.
For information about configuration of calibrators and controls, refer to
Calibrator/Control Configuration in Section 2, Installation
Procedures and Special Requirements of the AEROSET Systems
Operation Manual.
Assay Parameter Configuration
The Assay Configuration screen is accessed by selecting <Assays> in
the Information Access Area. From the ASSAYS screen select the
desired assay name (for editing an assay file) or an empty button (for
creating a new file).
This section will briefly describe the pages of the Assay Configuration
screen for photometric assays. For further information and details, refer
to Assay Configuration in Section 2, Installation Procedures and
Special Requirements of the AEROSET Systems Operation Manual.
• Do not go into detail
for all fields of every
page.
• Highlight items such as
Linear High and Linear
Low, dilution protocols,
reagents, and rerun
rules.
• Remind customer that
for all Abbott assays,
this information is
loaded from a disk. For
more information, see
the OPS Manual. This
will be discussed further
in AEROSET Advanced
class.
To Next Page
Loading...