Error Codes and Messages
AEROSET
®
Customer Training Guide 11-7
94858-103 — July 2003
Calibration Error Codes
Calibration Error Codes are displayed on the ASSAY STATUS screen.
When a Calibration Error Code is generated, the Result Error Code of
CAL is displayed with the corresponding assay results in the RESULT
and Reaction Graph screens.
NOTE: In addition, Error Code 37, “Calibration Failed, Check
Assay Status” is generated as an Error Log Message.
The Calibration Error Codes are listed with appropriate probable causes
and corrective action in Section 10, Diagnostics and Troubleshooting of
the AEROSET System Operations Manual.
An example of the ASSAY STATUS screen with a Calibration Error
Code is displayed below.
Figure 11.3: ASSAY STATUS Screen
Transmitted Error Codes
For each Result Error Code and Calibration Error Code, a single letter
code is included in the result transmission to the Host Interface system.
To display the Result Error Codes and Calibration Error Codes when
reviewing the results at the Host, the Host system must be defined with
an “interpretation table” and display the equivalent code.
The transmitted Error Codes are listed in the AEROSET Host Interface
Specifications.
• MON-switched calibrators, flat
curve.
• Wrong reagent (R2).
Calibration
Error Code
To Next Page
Loading...