MODULE 12: ACTIVITIES
12-6 AEROSET
®
Customer Training Guide
94858-103 — July 2003
Adding a Calibration
1. Review the Start-QC results for Albumin.
2. Pretend that the Albumin QC results are out of range.
3. Calibrate the Albumin assay and select the QC after Calib option.
4. Load the calibrators and initiate the run.
Rerunning Results
1. Confirm that Albumin calibration is complete.
2. Request that all the Albumin results on the patient samples be rerun.
3. Ensure that the samples are still onboard and available for sampling.
4. Initiate the run using the appropriate procedure for the System status
of your instrument.
5. While in the RUN OPTIONS screen, deselect the Limited Run
option.
Reviewing Results
When all results are complete, perform the following steps:
1. Select the rerun results on Albumin.
2. The sample used for the Calcium result on Al Lergy was manually
diluted 1:2, but you forgot to enter the Manual Dilution factor when
ordering the sample. Multiply the answer by 2 and edit the result.
3. Review all incomplete samples and accept or select the results.
4. Validate all samples.
5. The doctor requested a reprint of the report for Monty Zuma.
Request a print of Form 1 for this sample.
To Next Page