Basic Steps to Order and Run a Sample
AEROSET
®
Customer Training Guide 2-27
94858-103 — July 2003
Viewing System Status and Run Progress
During a run, there are three ways to monitor the progress of the run:
• By viewing the Run Progress Area (described in Module 1, System
Tour)
• By the System status displayed in the upper right-hand corner of the
screen
• By viewing the color change of the samples in the DATABASE
screen
System Status
The following System status types are displayed during a run:
Status System Action
READY The System is not performing any operation and is
ready to begin the run.
RUN The System is sampling and processing samples.
SAMPLING END The System has completed sampling and is
processing the samples.
CUVETTE FILL The samples are completed and the System is adding
water to the cuvettes.
SUSPEND The System is ready to perform a new run. During
this status the System begins the new run with an
abbreviated run initialization sequence.
PAUSE The Operator has paused the System by selecting
<PAUSE> in the Action Area.
To Next Page
Loading...