Working with Application Graphs Applications
Agilent 8163A/B, 8164A/B, and 8166A/B User’s Guide, Fourth Edition 215
Working with Application
Graphs
If you press the [Graph] softkey, a graph similar to Figure 135 appears.
This section explains how to use the graph.
There are four markers A, B, C, and D. You can use these markers to
choose the area of the graph that you wish to zoom into.
For the Logging and Stability applications, the time values of A and B
are displayed at the bottom of the screen in units of seconds. The
symbol ∆ that is listed directly beneath these values, displays the
difference between A and B in seconds.
For the PACT application, the wavelength values of A and B are
displayed at the bottom of the screen in units of nanometers (nm). The
symbol ∆ that is listed directly beneath these values, displays the
difference between A and B in nanometers (nm).
The power values of C and D are displayed at the bottom of the screen
in the chosen power units. The symbol ∆ that is listed directly beneath
these values, displays the difference between C and D in the chosen
power units.
Figure 135 The Application Graph
To Next Page
Loading...
Need help?
General
