Firmware Upgrades Firmware Upgrade Process
440 Agilent 8163A/B, 8164A/B, and 8166A/B User’s Guide, Fourth Edition
Agilent 8166A Firmware Upgrade Procedure
To upgrade firmware for the Agilent 8166A, you require a PC, running
MS Windows 95 or NT 4.0, or higher, plus a serial null-modem cable,
that was supplied with your Agilent 8166A mainframe.
Perform the following instructions (“xxx” in a filename should be
replaced by the current release number, i.e. 402 for release 4.02):
1 Copy the directory Firmware\8166A from the Support Disk to a
directory on your PC. This directory contains the files
"HPFlashWinR5.exe" and "66_flxxx.bin".
2 Click on HPFlashWinR5.exe to start the HPFLASH software.
3 Press the "File Selection" button, the file selection box appears.
4 Move to the file "66_flxxx.bin" and click on OK.
5 Click on 'Port Settings'.
6 Select the com port where the serial cable is connected. Choose the
maximum baud rate. Click on OK.
7 Turn on the 8166A and wait for the first beep.
Now you must be quick:
– Press and hold the Preset hardkey.
– Still holding Preset, press and hold the Aux hardkey.
– Still holding Preset and Aux, press and hold the Appl hardkey.
TIP Use three fingers and place them near the keys in advance!
If you were successful, you here a double beep and the display
shows that the instrument is in download mode. Otherwise, turn off
the power and try again.
8 Click on 'Program' and wait until the download completes. The
instrument will reboot with the new firmware.
To Next Page
Loading...
Need help?
General
