4 Agilent 8163A/B, 8164A/B, and 8166A/B User’s Guide, Fourth Edition
The Agilent 8164A/B Lightwave Measurement System complies with
overvoltage category II and can operate from any single-phase AC
power source that supplies between 100 V and 240 V at a frequency in
the range from 50 to 60 Hz. The maximum power consumption is 270
VA with all options installed.
The Agilent 8166A/B Lightwave Multichannel System complies with
overvoltage category II and can operate from any single-phase AC
power source that supplies between 100 V and 240 V at a frequency in
the range from 50 to 60 Hz. The maximum power consumption is 450
VA with all options installed.
Line Power Connection
In accordance with international safety standards, the instrument has
a three-wire power cable. When connected to an appropriate AC
power receptacle, this cable earths the instrument cabinet. The type of
power cable shipped with each instrument depends on the country of
destination. Please refer to “Accessories” on page 297 for the part
numbers of available power cables.
WARNING To avoid the possibility of injury or death, you must observe the
following precautions before switching on the instrument.
• Insert the power cable plug only into a socket outlet provided with a
protective earth contact. Do not negate this protective action by the
using an extension cord without a protective conductor.
• Do not interrupt the protective earth connection intentionally.
• Do not remove protective covers. Operating personnel must not
remove instrument covers. Component replacement and internal
adjustments must be made only by qualified service personnel.
• Instruments that appear damaged or defective should be made
inoperative and secured against unintended operation until they
can be repaired by qualified service personnel.
• Defective, damaged, or malfunctioning laser sources must be
returned to an Agilent Technologies Service Center.
• Do not operate the instrument in the presence of flammable gases
or fumes. Operation of any electrical instrument in such an
environment constitutes a definite safety hazard.
To Next Page
Loading...
Need help?
General
