Applications The Logging Application
228 Agilent 8163A/B, 8164A/B, and 8166A/B User’s Guide, Fourth Edition
Selecting/Deselecting Power Meters
3 Move to the Module Selection box. As a default, all Power Meters are
selected, this means that all Power Meters will log power
measurements. Press [Edit].
4 To deselect a Power Meter channel, move to the Power Meter as
denoted by slot and channel numbers, see “Slot and Channel
Numbers” on page 40, press [Unset].
5 To select a Power Meter channel, press [Edit], move to the Power
Meter as denoted by slot and channel numbers, see “Slot and
Channel Numbers” on page 40, press [Set].
6 Perform steps until you have selected the required Power Meters for
your application and press Enter.
NOTE If no Power Meter channel is selected, you cannot ‘exit’ by pressing
Enter.
Setting Power Meter Parameters
NOTE If you are using the Agilent 8164A/B Lightwave Multimeter, you may
set all Power meter parameters from the Logging Setup Screen, see
Figure 145.
To Next Page
Loading...
Need help?
General
